americanoob.blogg.se - Hard disk error repair

#Hard disk error repair software#
#Hard disk error repair Pc#

Remove the battery and makes sure all USB devices, power cable, etc.If your computer has fallen off or else has got jarred, it’s possible that the connection to hard drive gets loose. You can skip to step 5 for data recovery and drive repair process. This precaution can help you save your important data before the drive fails. Therefore, recover your data before proceeding to any step that involves the exhaustive use of the hard drive.

As the drive is already damaged, running Extensive test can lead to drive failure. NOTE: Diagnostics can fix most problems but it can also damage the hard drive. In case you are still stuck with the error, proceed to the next step This opens further options for diagnostics. If the hard drive passes the Quick Test but the problem is still unsolved, run Extensive Test after a restartĪlternatively, you can press the F2 key when the error appears on the screen after turning ON your HP laptop.

After the test, results are displayed.

If your system has more than one drive, select Test All Hard drives

Wait for the hard drive test to finish.

Select Quick Test and then select Run Once.

Choose the hard drive using the arrow key.

#Hard disk error repair Pc#

Select Components Test from the HP PC Hardware Diagnostics menu.Press the power button to turn the system ON and immediately start pressing the ESC key repeatedly 4-5 times.Press and hold the power button for 5 seconds to turn the system off (if it’s on).Plug in the AC adapter and make sure no other USB device is connected to the system.

To run diagnostics on hard disk, follow these steps: There are 6 different diagnostic tests that are performed either in Quick mode (takes 1-3 minutes) or extensive mode (takes more than 2 hours). If it still displays the same error, follow the next step.

Use the arrow to select Yes when prompted and then press Enter.

Press F10 to save settings and exit the BIOS.

Press F9 in the BIOS screen to select and load the BIOS Setup Defaults Setting.

Turn it ON and start pressing F10 to enter BIOS.

Turn off your system and wait for 10 sec.

To reset BIOS defaults on your HP laptop, follow these instructions:

Then install/connect the battery and turn ON your laptopĬheck if your system is able to boot completely.

Press and hold the power button for a while to discharge any remaining current on the board (stored in capacitors, etc.).

If it’s internal, open the laptop casing and disconnect the battery To hard reset your HP laptop, follow these instructions:

#Hard disk error repair software#

Following are some solutions that you can apply to your system and fix it.Ī hard reset wipes out everything from the computer memory (cache, RAM, etc.) & restores the default functionality thus, re-establishing software connection between the hardware and the BIOS that could probably fix the hard disk error.

However, in some cases, the problem can be caused by a malfunctioning hard drive controller but that’s rare.

Please run the Hard Disk Test in System Diagnostics.įor more information, please visit: In most cases, this problem resides within the hard drive. An HP laptop with affected hard drive displays the following error when you turn it on. The HARD DISK 1 (3F1) error can also occur due to damaged operating system files (caused by bad sectors on the hard drive). Hard disk error HARD DISK 1 (3F1) is associated with HP laptops and appears when the laptop hard drive that stores the OS gets damaged or corrupt. Are you facing HARD DISK 1 (3F1) error issue & don't know why receiving this error code? Then here is the answer of your question, this blog has everything you need to know about HARD DISK 1 (3F1) error and its solutions.